Sol-Gel Gateway Home page

 

 

 

 
  Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
Equipments and Processing Techniques
 Sol-Gel Gateway Forum>Sol-Gel Forum>Equipments and Processing Techniques
Message Icon Topic: Extrusion of sol-gel tubing(Topic Closed Topic Closed) Post Reply Post New Topic
Author Message
Brian Wilcox
Newbie
Newbie


Joined: 29 May 2001
Location: United States
Online Status: Offline
Posts: 1
bullet Topic: Extrusion of sol-gel tubing
    Posted: 29 May 2001 at 10:30am
I want to extrude a "glass-like" tube, approaching a cm in diameter and with walls about a mm thick, at room temperature. I want mechanical properties perhaps a tenth as good as glass, and for it to be impermeable to water. I would like it to extrude at a rate of a few mm/s.
Any suggestions?
IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump 		You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum




This page was generated in 0.047 seconds.
Privacy statement Copyright 2000-2013, Solgel.com.